5.8G 300Mbps Metal Case with Antenna Connectors Outdoor Base Station PoE Support
AP28 is an 5.8G outdoor CPE/AP with SMA antenna connector. Comply with IEEE802.11a/n standard, 300Mbps high speed data rate, Atheros industrial chipset, and 500mW high power PCB board design, it supply you a stable and freely WiFi networking.
Special:
Metal outdoor shell for outdoor weather protection and Atheros Industrial solution
AP28 with metal outdoor shell to avoid the damage from outdoor rain, dust and thunderstorm weather, adaptive to various environment, meanwhile, the auxiliary cooling function make AP28 work normal at -20℃ to 50℃, suit for any country.
Besides that, build in PCB board with Atheros industrial chipset, 300Mbps high speed, it widely be used in voice, video, data transmission area.
500mW High Power, with SMA connector for omni antenna for more range
AP28 with 500mW true power to boost the wifi signal for more wifi range.
Besides that, it with SMA connector, user can connect it with high gain outdoor antenna for more wifi range.
5.8GHz frequency, faster, lower latency, higher stability
AP28 with frequency of 5.180~5.825GHz, with wireless backbone channel of Europe, Japan, China, it avoid the same frequency interference problem, full meet with data transmission in fast speed, low delay, high stability requirement in wireless monitor.
Multi operation mode: Wireless AP, Wireless Router, WiFi Repeater, WISP, WDS
It support wireless AP, Gateway, WiFi Repeater, Bridge, WDS operation mode, user can flexibly choose a suitable wireless mode to build or extend the wireless networking based on exist networking structure.
Support Power over Ethernet, cost save
The device has integrated Power over Ethernet (PoE) for easy installation and lower cost, with 24V/48V PoE, it can be installed in areas where power outlets are not readily available, eliminating the mess of altering existing network infrastructure.
AC controller for Easy configure and central managed, captive portal authentication and advertisement optional
AP28 work with Yuncore’s AC controller for central management under wireless AP operation mode, then can work with cloud server for captive portal authentication or advertisement when AC controller or AP20 under gateway operation mode.
Main Function:
Comply with IEEE802.11a/802.11n standard. 300Mbps data rate
Support Bridge, AP, Gateway, WISP, WDS operation mode.
Support bridge and routing mode data forwarding and PPPoE two layer data packet transmission
Support automatic power adjustment and channel selection
Support multi security mode
Support users and traffic flow control
Support WLAN QoS function, support WMM protocol
Support MAC access control and WLAN interface
Support local management, access log and security log.
Support 10/100Base-T interface, meet with IEE802.3-2005 standard, and MDI/MDI-X auto connection function.
Wide working temperature: -20℃～50℃, can be used in any country.
Support Passive PoE in default, IEEE 802.3af PoE is optional
Spec:
| Standard | IEEE802.3af, IEEE 802.11n, IEEE 802.11a |
| Frequency | 5.180 - 5.825 GHz |
| Channel | CH36 ~CH165 |
| Modulation | 802.11n/802.11a: OFDM (64-QAM, 16-QAM, QPSK, BPSK |
| Data Rate | 11n: up to 300Mbps(dynamic) 11a: up to 54Mbps(dynamic) |
| Protocol | CSMA/CA,CSMA/CD,TCP/IP,ICMP,NAT,PPPoE, DHCP , Wired static , Wifi Client , UDP, DDNS, |
| Operation Mode | Bridge, AP, Gateway, WISP, WDS operation mode. |
| Security | 64/128bit WEP WPA(AES,TKIP with IEEE 802.1x) WPA2(AES,TKIPwith IEEE 802.1x) WPS |
| RF Output Power | 802.11n: 25±2dBm, OFDM module 802.11a: 27±2dBm, OFDM |
| Receive Sensitivity | 11n : -72±2dBm@10% PER 11a : -75±2dBm@10% PER |
| Antenna | SMA Connector, |
| Size(mm) | L: 153.2mm, W: 79.5mm, H: 234.5 mm |
| Weight | 2KGS |
| Working Temperature | -20°C ~ 50°C |
| Storage Temperature | -40°C ~ 70°C |
| Humidity | 10% ~ 90% (Non-condensing) |
| Interface | 1*RJ-45 Port 1*Reset button |
| Power | Output: POE 24V, 1A; Input: 110V/220V |
| LED Light | Power, WiFi |
